My subscriptions: PI Connectors

Showing 383 of 4921

Ability to monitor which OPC UA Connector is active in a failover pair

As a PI administrator, I need to monitor which OPC UA Connector in a failover pair is currently active. When the primary OPC UA Connector goes down, I need an email notification, and vice versa when the secondary OPC UA Connector goes down.

Guest over 2 years ago in PI Connectors / PI Connector for OPC UA 1 No status

13 VOTE

PI Connectors buffering (Tau) - provide configuration options

As a PI Administrator, I would like to be able to DISABLE or configure Tau buffering SO THAT after a network outage the flood of data doesnt overload my network switch and PI DA. My current use case doesn't require the data that may be lost during...

Guest over 2 years ago in PI Connectors / General 0 No status

12 VOTE

The connector creates too many tags

Currently, the connector will create 124 or 248 tags per data source, regardless of how many meaningful data points are actually in the data set. This greatly limits the use of the connector to any customer that is not an EA.

Allison Muraski over 2 years ago in PI Connectors / PI Connector for Ethernet/IP 0 No status

12 VOTE

Migration from interface to connector

Would like a way to migrate from interface to connector as easily as possible.

Guest over 2 years ago in PI Connectors / PI Connector for BACnet 2 No status

12 VOTE

Add failover capability for the BACnet Connector.

Failover similar to the UFO available for UNIint interfaces. Warm failover would be sufficient, although I'm sure there are some who would like cold and hot as well.

Chris Wozniak over 2 years ago in PI Connectors / PI Connector for BACnet 1 No status

12 VOTE

Switch for using Name of AF Attributes from Browsable Name or Display Name

Add a Switch to the OPC UA Connector that we can choose if we want the AF Attributes to be created using "Browsable Name" or "Display Name". Using the Display Name would make it much easier for us to locate the Attribute and refer to its OPC Tag a...

Guest over 2 years ago in PI Connectors / PI Connector for OPC UA 2 No status

12 VOTE

Increase the default log size

The current default log size in the event viewer is 1MB. Although it can easily be increased, a larger default (100MB+) would allow to catch errors the first time they occur and allow for further troubleshooting then having to change it and have t...

Gabriel Verreault over 2 years ago in PI Connectors / General 0 No status

12 VOTE

PI Connector for MQTT - support more generic JSON formats

While the existing support for Sparkplug MQTT format is helpful, this connector would be more useful if it also supported a more generic JSON format.

Guest over 2 years ago in PI Connectors / General 3 Declined

12 VOTE

Add a Boolean data type

Boolean variables are useful for reusing Boolean (sub)expressions, concise debugging of the value of a Boolean expression, and extraction and storage of Boolean values before writing to Int32 PI status tags (e.g. on/off status, open/closed status).

Kenneth Barber over 2 years ago in PI Connectors / PI Connector for UFL 1 No status

12 VOTE

Be able to modify the PI Point prefix from the PI Connector for UFL administration page

It does not make sense that edits to some of the PI Connector for UFL's JSON files can be done through the administration page, but not all. The administration page should be a 1-stop configuration shop.

Kenneth Barber over 2 years ago in PI Connectors / PI Connector for UFL 3 No status

Please enter your email address

FILTER BY CATEGORY