PI Interfaces

Showing 305

Assure changes made to any configuration of an interface are audit trailed

We noticed that changes to the configuration of newer interfaces / connectors like - PI EMDVBCS interface 4.0 - PI inbatch interface - PI Connector Wonderware Historian are no longer recorded in the PI Audit trail. (see also TechSupport Case # 9...

Carl Van Laer about 2 years ago in PI Interfaces / General 0 No status

5 VOTE

Device Status UniInt health tag should update during runtime without needing a status update

Currently, the device status is updated on startup, on change, on shutdown, and on each performance summary interval. However, for a device status tag created while the interface is running in a good state, the device status tag will remain at 'P...

Guest about 2 years ago in PI Interfaces / General 0 No status

5 VOTE

Avoid reloading tags after edits of non-key PI Point attributes

Currently, UniInt-based interfaces will reload a tag if edits are detected on any of the PI Point attributes. This is not ideal as edits to non-key attributes (such as EngUnits) will still cause a tag to be reloaded, potentially leading to data so...

Guest about 2 years ago in PI Interfaces / General 0 No status

5 VOTE

Delete mode in Wonderware InBatch interface

When run in delete mode for WWInBatch interface, it uses the data source as the system of record--any open batch in SQL will be deleted. However, as abandoned or done batches are open in WonderWare but closed in PI, the interface may delete ...

Willy Seah Wei Liat about 2 years ago in PI Interfaces / Batch Interfaces 0 Declined

5 VOTE

Double check window required when deleting an instance in PI Event Frames Interface Manager

As a PI System Admin, I would like to see a confirmation window (acceptation pop-up message), when deleting Interface instances in PI Event Frames Interface Manager. This would minimize the deletion of the instances by error.

Guest about 2 years ago in PI Interfaces / Batch Interfaces 0 No status

5 VOTE

Enhance Visibility of Event Frame Generator/Batch Interface History Recovery Status

Currently when running any event frame generator interface (EFGen, PIFTBatch, etc.) in history recovery mode, there is no way to monitor progress of the actual history recovery. The only way to determine status is to check message logs periodicall...

Guest about 2 years ago in PI Interfaces / Batch Interfaces 0 No status

5 VOTE

Batch Interface for Honeywell Experion

We are in need of a PI Batch/AF Events Interface to store data from Honeywell Experion Batch or Honeywell Procedure Analyst into PI Asset Framework.

juergen.b.schmidt about 2 years ago in PI Interfaces / Batch Interfaces 0 No status

5 VOTE

SNMP: Throttle scan specific informational messages as the interface may fill up logs every scan frequency

This is for SNMP version 1.6.3.0, the following message is printed every scan frequency: "Scan class for device will be skipped due to previous pending requests" And this needs to be throttled as the logs may be get filled up quickly with th...

Guest about 2 years ago in PI Interfaces / Other Interfaces 0 No status

5 VOTE

DNP3: store data as "bad"

Add functionality to treat the data as "bad" and send a digital state instead, when status flags are sent with the event and status bits are set to TRUE. Right now, the data is sent to PI and marked as "questionable". Note: This was previously En...

Clint Ramsey about 2 years ago in PI Interfaces / Other Interfaces 0 No status

5 VOTE

Allow PI APS to rename PI Points

PI APS is now not able to rename a PI Point name. If the item name is changed on the Datasource side we wish that APS rename the Pi Point.

Guest about 2 years ago in PI Interfaces / Other Interfaces 2 No status

Please enter your email address

FILTER BY CATEGORY