All ideas

Showing 4929

Configure target PI/AF/DB at datasource level

Actually the UFL Connector sends data to all of the listed PI Data Archives and AF Servers in the server list configured in administration page, so it's not possible to send different data to different PI DA or AF databases with a single UFL Conne...

Carlo Pedroli over 2 years ago in PI Connectors / PI Connector for UFL 0 No status

9 VOTE

Support multiple Modbus devices on the same machine

Add support for multiple Modbus devices (using the same IP address but different port numbers) on the same machine. For example, the interface could allow the user to configure something like this: /dn= xxx.xx.xxx.xx:43120,/cn=1,/polldelay=0,/to...

Guest over 2 years ago in PI Interfaces / PI Interfaces for Modbus 3 Declined

9 VOTE

Log bad timestamps for the PI RDBMS Interface

When the PI RDBMS Interface gets a bad timestamp from the source RDB that it cannot coerce into a PI Timestamp, the actual bad timestamp received from the RDB should be logged as part of the error message. This would coincide with the following e...

Guest over 2 years ago in PI Interfaces / PI Interface for RDBMS 0 Future consideration

9 VOTE

and operator

Add a function that can be used in the UFL Configuration File to perform bitwise operations. For example, a function similar to the AND operator in Performance Equations and Asset Analytics.

Guest over 2 years ago in PI Interfaces / PI Interface for UFL 1 Declined

9 VOTE

Allow PItoPI APS connector to sync "Point Type" changes

Currently (as of PI to PI Interface AutoPointSync Connector Version 1.5.0.7), it's not possible to sync changes to "Point type". (See pg 5 of user manual). Please make this possible in a future release.

Guest over 2 years ago in PI Interfaces / General 0 Declined

9 VOTE

PI OPCtoCSV tool to continue running and skip branches in error

The PI Interface for OPC DA is packaged with the PI OPCtoCSV tool which extracts all OPC Items. When the tool is run into error with certain branches, the tool will stop and disconnected from the OPC server/tunneller. For example: “GetItemProperti...

Ee Sheing Lee over 2 years ago in PI Interfaces / General 1 Declined

9 VOTE

efgen

Allow EFGen to use a Mix of PITAG + Text for the Creation of event frame names . Concatenate a Text + PITAG for example

valeman over 2 years ago in PI Interfaces / Batch Interfaces 4 No status

9 VOTE

PI integrated with Project Haystack tag standard. See www.project-haystack.org for more information.

It would be very helpful if PI integrated the PI Connector with the Project Haystack tag standard. See www.project-haystack.org for more information. Project Haystack is an open source initiative to streamline working with data from the Internet ...

Guest over 2 years ago in PI Connectors / New PI Connector Request 0 No status

9 VOTE

PI System connector creates additional data on start up

When PI System connector is stopped and started (as a service or in UI), duplicate event is received and archived by the target PI Data Archive. The write mode for the PI Connector Relay is append, in this case history recovery will include/send t...

Guest over 2 years ago in PI Connectors / PI System Connector 0 Declined

9 VOTE

PI Interface for IEEE C37.118 support for Analog data Signed and Unsigned 16-bit Integers

The IEEE specification of the IEEE C37.118 protocol does not specify if analog data should be singed or unsigned for 16-bit integers. The currently the PI Interface for IEEE C37.118 represents these values as exclusively unsigned. Both types shoul...

Guest over 2 years ago in PI Interfaces / Other Interfaces 0 No status

Please enter your email address

FILTER BY CATEGORY