Search results: General

Showing 4 of 94

PI Connector Relay support write modes

While writing data to PI through the connector relay there seems to be no option to control the write mode . E.g."[-109] Value at This Time Already Exists" is shown in the logs if the archive already contains an event with the same timestamp. The ...

Guest about 3 years ago in PI Connectors / General 2 No status

4 VOTE

Add Event IDs to event logging

Currently, events logged for the OPC UA Connector all have an Event ID of 0. I've had to dig around in Event Viewer quite a bit for troubleshooting, and it's frustrating not to be able to filter events by ID. I mention the UA Connector because tha...

Guest about 2 years ago in PI Connectors / General 0 No status

5 VOTE

Write an error message to logs when no destination PI Data Archive is specified

Ran into this problem when configuring a new UFL connector. After install, I went straight to configuring my .ini--forgetting to add the PI Data Archive (in fact, the connector was actually installed on the DA node). I had the text files coming ...

Guest about 3 years ago in PI Connectors / General 0 No status

1 VOTE

Write e-terrahabitat log messages to the PI Message log

Certain information such as digitalsets that do not match the definitions in SCADA are only logged in the Windows Application log. It would be extremely helpful if this information could be written to the PI Message log. This would all...

Allison Muraski about 3 years ago in PI Connectors / General 1 No status

Please enter your email address

FILTER BY CATEGORY