AVEVA™ PI System™ Feedback Portal

Welcome to our feedback site!


We created this site to hear your enhancement ideas, suggestions and feedback about AVEVA products and services. All of the feedback you share here is monitored and reviewed by the AVEVA product managers.

To start, take a look at the ideas in the list below and VOTE for your favorite ideas submitted by other users. POST your own idea if it hasn’t been suggested yet. Include COMMENTS and share relevant business case details that will help our product team get more information on the suggestion. Please note that your ideas and comments are visible to all other users.


This page is for feedback specifically for AVEVA PI System. For links to our other feedback portals, please see the tab RESOURCES below.

ADD A NEW IDEA

Clear

Search results: General

    Showing 8
    210 VOTE

    Monitoring Connector health

    Support for health tags (similar to UniInt health tags), Windows performance counters, or any other way to bring Connector status and health information into PI tags to put them side-by-side with Interface health monitoring.
    Guest over 3 years ago in PI Connectors / General 42 Declined

    PI Connector for IEC 60870-5-104 bi-directional between SCADA and PI

    RWE Power AG “But one really important feature we need, is the ability to write back from PI into the SCADA system Until now, we couldn’t find anything about this (important) functionality. So our question is if we can use this connector bi-dire...
    Guest over 3 years ago in PI Connectors / General 4 Declined

    PI Connector for MQTT - support more generic JSON formats

    While the existing support for Sparkplug MQTT format is helpful, this connector would be more useful if it also supported a more generic JSON format.
    Guest over 3 years ago in PI Connectors / General 3 Declined

    Failover for PI Connector Relay

    Although, the PI Connector Relay going down / not being available does not cause data loss since the connector data is buffered, if the source connector supports Failover, the relay becomes the only single point of failure in the data flow. Havi...
    Gabriel Verreault over 3 years ago in PI Connectors / General 4 Declined

    OMF Support PI Connector Relay

    Keep the OMF support in PI Connector Relay, also add the new OMF Versions to it not just only OMF 1.0. Not just leave the OMF support to the PI WebAPI. In many customer scenarios, the PI Connector relay is an easier solution than PI WebAPI.
    Guest over 3 years ago in PI Connectors / General 0 Declined

    Support Failover at the data source level

    For PI Connector (1.x) that support failover like OPC UA, failover will only occur when all data sources get into a bad state. Failover should not have to be configure at the PI Connector node level, but for each data source. Use case 1: If 3 con...
    Gabriel Verreault over 3 years ago in PI Connectors / General 1 Declined

    Selectively send source data to PI based on triggering conditions

    Example 1: If Circuit Breaker trips, begin sending high frequency load, voltage data, etc. Under normal operations do not send this data. (condition must allow for definition of a moving window, i.e. Trip occurs, data just before the trip must be ...
    Guest over 3 years ago in PI Connectors / General 0 Declined

    Selectively send source data to PI based on network connectivity

    Example: - If on network A (which could be satellite or 3G) send Tags 1-10 and buffer Tags 11-50. - If on network B (Wifi, wired), flush buffer and send all Tags 1-50. Requested by OSIsoft Transportation Team, but very beneficial for all remote ...
    Guest over 3 years ago in PI Connectors / General 0 Declined